News & Events

News & Events


Manufacturers and Importers of Children’s Products Prepare for Heightened Regulations

Bookmark and Share

Under the Consumer Product Safety Improvement Act of 2008 (“the Act”), the amount of allowable lead in any component part of a product intended for children ages 12 and under was reduced, effective February 10, 2009, to 600 parts per million, or “ppm.” The Act also mandated a series of further reductions in allowable lead content in component parts, ultimately reaching as low as 100 ppm, if technically feasible, by August 14, 2011. Prior to that date, however, there are two intermediate steps that manufacturers and importers of children’s products must meet by August 14, 2009:

  • No more than 300 ppm of lead in any accessible component part of a children’s product; and
  • No more than 90 ppm of lead in any paint or other surface coating of a children’s product.

In February 2009, the Consumer Product Safety Commission issued a stay of enforcement covering many of the requirements under the Act. This stay ostensibly postponed for one year manufacturers’ and importers’ obligations to obtain third-party testing and certification of compliance with allowable lead content in component parts of children’s products. While the stay has been beneficial in alleviating some logistical difficulties relating to testing and certification for some products, it unfortunately has not resulted in any meaningful reduction in potential liability for market participants. Worse still, the stay may have lulled some manufacturers and importers into complacency with the intermediate and ultimate requirements of the Act.

View full article (PDF).